NO. KI32
US dollar price:
BLACK:32
SAND:32
AEG CORE:30
new wale ordinary version M4 :30
BLACK:32
SAND:32
AEG CORE:30
new wale ordinary version M4 :30
need to connect black cow individual AEG patch m5 threaded line slot:13
Dimensions after product packaging about:25cm * 15cm* 5cm
Gross weight of product packaging: 0.250Kilogram
To install XM316/J8, you can send a patch - the patch is described below.
AEG core interface part the inner diameter is 22.16mm
The three sides have M4 locking holes
The outer diameter of the patch is 22.40mm, which needs to be sanded to 22.10 by itself, and then it works well.
Then it can get J8-XM316 without trace.
This patch can be sent.
But you have to leave a message
The rear support factory surface is not very good
We try to mix the paint then renovate
This nylon surface is very hard to spray
Every product is carefully sprayed with paint.
The spray paint of this material is not low
The rear support needs to be purchased separately core to install on the AEG interface.
Ordinary version is that the outer diameter of the tail is 22.20mm, which can be directly installed without gaps
Core surface dumb light the quality is very good
To install XM316/J8, you can send a patch - the patch is described below.
AEG core interface part the inner diameter is 22.16mm
The three sides have M4 locking holes
The outer diameter of the patch is 22.40mm, which needs to be sanded to 22.10 by itself, and then it works well.
Then it can get J8-XM316 without trace.
This patch can be sent.
But you have to leave a message
The rear support factory surface is not very good
We try to mix the paint then renovate
This nylon surface is very hard to spray
Every product is carefully sprayed with paint.
The spray paint of this material is not low
The rear support needs to be purchased separately core to install on the AEG interface.
Ordinary version is that the outer diameter of the tail is 22.20mm, which can be directly installed without gaps
Core surface dumb light the quality is very good
