1, this product is adjustable friction up and down, the new wale G36 generation two generation general, without grinding, no need to use glue, the original plant, the installation of the word upwards, insert the end. The diameter of 19mm, metal decorative cap can be installed inside the 19mm, is not compatible with the original blue cap.

 

 

2, through the attached six angle wrench to rotate the top surface of the screw, the angle of the upper spin can be adjusted to adapt to the different size and hardness of the water elastic. It is recommended that the size of the water bomb is 7.0-7.4mm.

 

 

3, when the water bounce is good, it must be drained and reused, or dry water over the towel. Otherwise, the surface moisture of the projectile is too much. It will weaken the effect of the upper spin friction and cause the urine bomb.

 

 

4, when you screw the screws, please be careful and light to prevent damage.

 

 

5, the friction strip is limited to prevent excessive bending and fracture. The lower opening can drain and drain, accelerate the evaporation of the friction plate, and make the upper friction effect more durable.

 

 

6, the principle of 3D printing is made by layer by layer. It is bound to produce lines and joints. This is a normal phenomenon. It is a non quality problem. After all the upper spin checks are qualified, the goods are shipped, and there is no burr on the inner wall.

 

 

7, the rotary solid print ABS plastic, PLA plastic Xingyuan ultra high temperature in summer, there is no need to worry about thermal deformation.